Facts That Nobody Told You About How To Cut Bx Cable

How To Reduce Bx Cable –

Photo credit Colorado Armored Cable

Armored cables, or cables that are sheathed in steel armor, defend your wires even though nonetheless providing flexibility. Nevertheless, the armor makes cutting a challenge. Comply with the actions under to cut your armored cables appropriately with a hacksaw.

Step 1 – Preparing Your Tools

If you have an armored-cable cutter, you can use this for the job. However, if you do not have one of these particular tools, you don’t require to go out and acquire one. Alternatively, use a hacksaw and the following steps.

Step two – Holding the Cable and Saw

Initial, hold the cable firmly in a single hand while holding the hacksaw in the other. Hold the saw and cable so that, the blade is at a 90-degree angle to the cable.

Step three – Sawing the Cable

Warning: Use all proper security precautions when functioning with a hacksaw and wear protective eye gear.

Then, commence sawing. Reduce at an angle across the spiral, not straight down.

If you’re cutting the cable to use it for a connection, cut about 8 inches from the finish of the cable to allow rooms for the wires to be run. Continue sawing until you have practically sawed via the armor, and cease.

Step four – Bending the Cable

Get rid of the saw, and then bend the cable till the armor breaks. To remove the armored cable from the wire beneath, gradually pull it off over the end until the wires are completely exposed. If you want to replace the armored cable, installing armored cable is straightforward.

Read More:  Shocking Facts About Terazzo Shower Base

How to Reduce Armored Cable