Heat Pump Filters – A heat pump filter is a important component of your heat pump. It helps to maintain dirt and debris from becoming discharged into your house. Heat pumps draw cool air into the device and distribute warm air inside the house. Prior to the cool air is drawn into the pump, it is filtered to eliminate dust and debris. This aids to maintain cleaner air indoors. With time, the pump filter accumulates a lot of dirt and debris. This reduces efficiency of your heater. It is best to modify the filters routinely for better overall performance of the heat pump. This is a straightforward job that does not take a lot time or work, as outlined under.
Step one – Cut Energy Supply
Turn off the power supply. Find the electrical panel and turn off the circuit breaker. This assists to prevent electrocution although you function.
Step two – Locate the Access Door
This is generally located on 1 side of the pump. Examine the door. You could discover that you can merely lift off the door from the hooks that safe it in location. Other heat pumps have the door secured with screws. Use a screwdriver to take away all the screws from the door. Spot them in a protected place to enable straightforward retrieval later. Remove the access door and location it aside.
Step three – Remove the Filter
Trace the blower compartment inside the heat pump. Check either below the blower or alongside for the filter. Get rid of the filter.
Step four – Note the Filter Specifications
Check the filter for particulars of the item. Write down the specifications in your notebook. Take this along to the retailer with you. It will enable the salesperson get you a equivalent product that will fit correctly in your pump.
Step five – Clean the Pump
Dip a rag into a bucket of warm water and wring it. Use the rag to wipe away dust and dirt inside the pump. Clean the outside of the pump as well. Rinse the rag many times as you wipe. This will make certain that you don’t spread dirt on your pump.
Step six – Install New Filter
Slide the new filter inside so that it requires the spot of the old a single. The airflow arrows on the filter ought to point towards the blower. Be sure to firmly attach the filter within its website in the blower compartment.
Step seven – Replace the Access Door
Use a damp rag to clean each sides of the access door. You want to make certain that every single part of the heat pump is effectively cleaned when it resumes operation. Attach the access door back onto the pump. If you removed screws, spot them in the door. Safe the screws with your screwdriver.
Step eight – Restore Energy
Go to the main electrical panel and turn on the energy. Switch the pump on. It need to perform efficiently, thanks to the modify of filter. For optimal performance of your heat pump, it is very best to replace your filters every 3 months.