Here’s What No One Tells You About How To Replace A Window Pane In A Metal Frame

How To Replace A Window Pane In A Metal Frame –

Replacing broken glass from metal window frames is a daunting process. You have to be careful when dealing with glass so as not to damage the glass as nicely as injure yourself. Realizing how to refit the glass pane of your metal window is a helpful talent considering that replacing a glass pane is one of the most widespread home repairs that you would have to do. Below are the components that you want along with the directions on how to replace glass in metal window frames.

Step 1-Clear Metal Window Frame of All Glass

Use your heavy work gloves as well as your safety goggles and get rid of all the broken glass. Do this from the outdoors of the area. Use masking tape or duct tape and use a crisscross motion on both sides of the glass. Tap it carefully employing a hammer and break the glass off. The tape will stop the entire glass from shattering into little pieces.

Step two-Take Out Spring Clips

Take away the spring clips that are attached to the glass and the metal window frame. Buy new spring clips from your neighborhood hardware or property improvement retailer so that you will have adequate spring clips to use.

Step three-Remove Old Putty from Frame

Employing a chisel or flathead screwdriver, get rid of the old putty that is stuck onto the metal window frame. Soon after removing the old putty, you can sand the remaining region on the window frame to make certain that it is smooth and flat.

Read More:  How Much Do You Know about Safe Outlet Covers?

Step 4-Take Measurements

Measure the edges of the interior region of the frame. The new glass piece must be 1/eight inch smaller sized than what you measured for the opening of the frame. Install the new glass piece. Be confident to purchase the exact same variety of glass as what you previously had.

Step 5-Apply Window Putty and Install New Glass

Take a bit of window putty and roll the putty in your hands until you form a extended cord of putty that measures about ¼ of an inch in thickness. Place the putty about the entire metal window frame. Use a putty knife to press down on the putty. Take the new glass and location it firmly on the glazing compound.

Step 6-Secure Glass

Use the spring clips and snap the clips on the predrilled holes situated on the metal window frame. Secure the new glass in location. They must be spaced out each six inches.

Step 7-Seal Window

Use a putty cord measuring 3/eight of an inch thick and place this around the exterior edge of the metal window frame to seal. Apply some pressure onto the putty.

Step eight-Apply Glazing Compound 

Use your putty knife, hold it at a 45-degree angle, and smooth out the glazing compound. Apply some water on your putty knife amongst strokes to prevent sticking. Use a razor blade to scrape off any excess putty. Let this set and dry for a handful of days.

How to Replace the Glass in Metal Window Frames