How To Cut Tile – A lot of property improvement enthusiasts currently know how to reduce holes in tile. They usually use a tile saw for in depth projects however, tile saws are a specialist piece of equipment. Unless you’re organizing to do a lot of tile operate, you’re not going to want the price of purchasing or renting a unit.
There are techniques to reduce holes in tile with the tools you could currently have in your workshop. It can take a fair quantity of patience. Make a couple of practice runs on old tiles to make sure you have the strategy appropriate before you move onto the genuine point.
Cutting Small Holes
If you only need to cut a tiny hole, you can do it with your regular drill. You’ll need to have to use a masonry drill bit, which ought to be either carbide-tipped or diamond-tipped. It should not matter if the tile is glazed or not.
On the back of the tile, measure and mark exactly where you want your hole. Utilizing a sponge, completely wet the location exactly where you’ll be drilling. Make sure the tile is not on a surface that can be damaged when you drill by means of and make positive the tile is properly supported by utilizing a clamp to hold it in place. As you drill, use a spray bottle to maintain wetting the tip of the bit. This will make sure a much better, cleaner reduce and should support stop burn marks on the tile itself.
Drilling Larger Holes
All as well often you will require a significantly larger hole in the tile. On the unglazed side of the tile, mark the position and size of the hole as nicely as the position in the center of the hole. Commence by drilling a hole in the center, just as you would with a little hole. It need to be as least .25-inches in diameter and big enough to insert the blade of a hacksaw. This will need to be a carbide rod blade.
Put the blade in the hole and then attach it to your hacksaw. The tile wants to be firmly clamped. Slowly saw out to the line marking the edge of the hole, then steadily saw about the complete perimeter of the hole. You want to take particular care on the final strokes to full the hole given that this is when tiles are most probably to crack. Employing the hacksaw will give a clean edge to the hole.
When you have a hole that’s so massive that it includes a lot more than 1 tile (meaning that it is probably to in fact involve four tiles to incorporate 1 huge hole), then you’ll want to eliminate an arc from each and every tile. In this case, it’s essential to lay issues out meticulously 1st prior to you mark the unglazed side of the tile. Make a diagram and number the tiles on the back so you’ll know which tiles go where when you lay them.
Score every single element of the arc with a tile knife. Now make cuts in every tile perpendicular to the arc. You’ll require to make a number of cuts, every about .25-inches apart. When you’ve done this, use a pair of tile nippers to snip off the part of the tile inside the arc. You may well need to have to use the nippers more than once to make a clean edge to the hole.