Learn All About Stamped Concrete Sealer

Stamped Concrete Sealer –

Concrete driveway sealing is portion of a excellent upkeep plan for those with stamped concrete. When undertaken on a standard basis, it will assist extend the life span of your driveway significantly. The color and luster of a concrete driveway tends to fade with time, and sealing aids to sustain the colour vibrancy. It is greatest to seal your driveway each 2-three years, nevertheless, the 1st sealant must be applied six months soon after installation. Under are 5 upkeep ideas that will help you preserve your driveway in good condition for longer.

When to Apply Sealant

It is very best to apply sealant throughout cooler climate. The fall or spring are most excellent. Do it in the early morning, just before ten am or in the evening, following four pm. Do not apply sealant in hot climate. The high temperatures will hinder correct setting.

Clean Just before You Seal

Dust, dirt and debris always gather on the driveway. Typical cleaning is a good concept as it will maintain your driveway looking its ideal. Just before you seal the driveway, you need to do the normal cleaning as a preparatory measure. This will clear the driveway of all dirt, leaving the surface clean and ready for sealant. Use a garden hose to rinse the driveway. Apply some liquid detergent and scrub with a medium-bristled brush. Rinse with sufficient water to clear all traces of soap. Enable a day or so for the driveway to dry fully. You can use a leaf blower if you want it to dry faster.

Sealer Preparation

It is critical that you prepare an sufficient quantity of the sealant that will cover the whole driveway. Usually, a five-gallon container must be adequate for 1,000 square feet. Add a single jar of anti-skid material into the sealant and mix it nicely.

Read More:  All You Need To Know About Solid Oak Coffee Tables


Apply the sealant in tiny sections. This will guarantee that you do a thorough job and cover the whole driveway. Use nap rollers to apply sealant. Begin at one particular end of the driveway and perform your way across and upwards. Let enough time for the very first coat to dry well. It might take a couple of hours. When it does not feel sticky you can proceed to apply a second coat. Operate in a similar manner as in the course of initial coat application.


When sealing driveways, it is essential to enable the sealant to dry completely before you use the driveway. 24 hours ought to be sufficient time.

Mistakes to Steer clear of

  • Do not apply sealer to driveway before you clean it very first.
  • Do not apply sealer to a damp or wet driveway.
  • Do not apply sealer with a sprayer. It is greatest to use a nap roller as a sprayer doesn’t transfer the anti-skid material. It will clog the sprayer.
  • Do not fail to stir the sealant after you start application. Failure to stir will result in the anti-skid remedy to separate from the sealant. Be certain to hold stirring the solution.
  • Do not apply a second coat prior to the very first coat has dried nicely.

Stamped Concrete Driveway Sealing: 5 Suggestions