Here’s What No One Tells You About Pegboard Hook Locks

Pegboard Hook Locks – If you have ever utilised hooks in a pegboard, then you know how frustrating it can be when the hooks fall out even though you mess with them. There is a basic resolution for that difficulty even though, and it comes in the kind of a pegboard hook lock. This simple, but brilliant device fundamentally puts a flat bar on best of the bottom section of the peg so that it does not come loose. You can purchase packages of these issues, bu they could not work for the pegs you happen to be using or for the pegboard you have. Then once again, you may well just be seeking for a craft project. In either case, follow the guide beneath to make your own hook lock.

Awesome Pegboard Hook Locks

Awesome Pegboard Hook Locks

Amazing Pegboard Hook Locks

Amazing Pegboard Hook Locks

Measure the Lock

To make your pegboard hook lock, you happen to be going to be spanning 3 rows of pegs and generating a bump over the peg itself. You need to allot for about a half inch of wire on either side as well so the lock can be inserted into the peg. Measure out the span of the three rows and then add 1 1/two inches to accommodate for the bump and the insertion points.

Cut the Wire

Along the straight extended edge of the wire hanger, mark the measurements you created earlier. Then cut off the ends so that all you have is one particular straight piece of thick wire. You will use a wire cutter to do this. Be certain to wear security gloves at all times in this project. The edges of the wire can get quite sharp and the last point you want is a basic do it oneself project to finish in bandages.

Elegant Pegboard Hook Locks

Elegant Pegboard Hook Locks

Lovely Pegboard Hook Locks

Lovely Pegboard Hook Locks

Luxury Pegboard Hook Locks

Luxury Pegboard Hook Locks

Make the Center Bump

This portion can get a small tricky. Start off by finding the precise center of the wire. Use a metal peg and bend the wire around it to exactly where it wraps half way about the peg. Then make a mark evenly on both sides of the bump that make it into a half circle. Take your pliers and bend the wires back along that mark so that you finish up with a straight line, a bump, and an additional straight line. This will appear like the sun coming over the horizon.

Read More:  Unbelievable Facts About Basement Wine Cellar

Make the Securing Bends

When you have the wire flat once again with the bump in place, put it up against the peg board and have the bump more than 1 row of holes. Mark exactly where the wire crosses the center of the holes on the rows directly subsequent to the bump. Then take the pliers once again and bend the wire so that it types a proper angle. You need to now have a piece that appears like a football purpose with the bump facing the opposite way of the posts. To finish it off, bend the back of the posts so they will not fall out of the pegboard.