Reliable Sources To Learn About How To Remove Shower Drain

How To Remove Shower Drain –

Shower drains final a long time, but eventually they will need to be replaced. A plumbing skilled can take care of the difficulty for you , or you can try to replace it oneself. You can total this job yourself with a handful of materials from your local property improvement retailer. Replacing your shower drain is rather simple. You will need access to your basements, or crawl spaces in order to total the function. Follow these methods to replace a shower drain.

Step 1 – Get rid of Old Drain

The old drain is at times difficult to eliminate. Use the hacksaw blade to reduce as much of the drain out as possible. If there are components that you can not get rid of with the blade, use a screwdriver to force them off. Pull the drain fully out and remove the washer as well. You will have to stick your hand in the drain to get the washer out.

Step two – Place Elements in Spot

Spot the nut and rubber washer in place. They need to have to be placed in the sink, down into the shower drain, under the tub line. Subsequent you will add a soft flexible washer or plumber’s putty. Set the prime of the drain into place and screw all of the elements together. It is especially crucial that you don’t over tighten as you screw the components together, due to the fact if you do, the threads will not work appropriately.

Step three – Test Match the Drain

Test the drain to make sure it fits prior to you seal it into location. Connect the swivel connector to the p-trap of the pipes. Attach the female side of the trap to the drain pipe. Subsequent, connect the swivel nut to the elbow pipe that measures a 90° angle. Once you have determined that all of the pieces fit with each other properly, separate them and set them aside to be sealed. If the new drain seems too brief, you can add onto the drain pipe or shorten the base of the swivel connector.

Read More:  Reliable Sources To Learn About Cleaning Bamboo Floors

Step 4 – Glue the Drain

Glue all of the pieces collectively utilizing an all objective cement. Glue the swivel connector to the p-trap. Subsequent, glue the 90° elbow to the drain pipe. You have to make confident that it is in the suitable position. Mark it with a grease pencil throughout the test fit. Then be positive to glue them together in the same way that you fit them collectively for the test fit. You want a excellent seal on these pieces, so apply glue generously. Screw the remaining pieces with each other and verify for leaks. Replacing your old shower drain does not have to be the job of a expert.

How to Replace Your Old Shower Drain