Replacing Mailbox Lock – Installing a mailbox lock is rather effortless and does not demand professional assistance. You can use the following directions to install a new mailbox lock.
If you are installing a mailbox lock on a new mailbox, the approach is a bit easier given that you don’t want to remove the older, dysfunctional lock. Nonetheless, if there is an older lock, take away it systematically without having harming the mailbox’s configuration. To do this, search for the big, horse shoe-shaped pin that is utilized in most contemporary mailboxes.
This pin is the major component holding the lock in its position. Search for a small tab-like depression that is present atop the locking mechanism of the old lock. The tab can be held with a pair of pliers to achieve a far better grip. Applying pressure on the pliers, pull at the tab, pulling it upwards. Guarantee that you disengage the lock by sliding it out of its position rather than pushing at it.
Step 2—Sourcing New Mailbox Lock: Cylinder Mailbox Locks
If you want an precise replacement like the older lock, carry the removed lock to the hardware store. Mailbox locks are simply discovered across all hardware retailers and even on on-line stores. Please note that it is far better to use a mailbox lock that gives the standard locking technique.
The most advisable variety in this regard are cylinder locks. These are straightforward-to-handle locks that can be very easily operated with no compromising the safety of the mailbox. These locks are retailed with a pair of keys that give simple opening/closing mechanism. It is far better to pick mailbox locks with an outer, all-climate coating of steel. This guarantees that the lock is protected against moisture-induced difficulties.
Preparing Base for Mailbox Installation
Please note that practically each type of mailbox construction is comparable to the standard pattern of a cylindrical mailbox lock. You require to prepare a void to match in the cylinder part of the lock, which is its main, internal locking component. This hole has to be made on the front door of the mailbox.
Most of the locks are retailed within a conventional size range. This indicates that your hole should be at least five/8 inch wide and three/four-inches tall. Use a drill for producing the holes. If you have a metallic mailbox, there are dedicated brackets for securing the mailbox lock into its position, so no drilling is necessary.
Inserting New Mailbox
Take-out the new lock from its packaging. Insert the locking bar of the lock inside the hole. Turn towards the inside surface of the mailbox door and reset the locking pin. This is rather effortless given that there is only one slot in the locking mechanism wherein the locking pin has to be inserted.
If you have a metallic mailbox, you need to insert the locking bar in the little space among the brackets and tighten the brackets. The realigned brackets may have to be pressed upon with a screwdriver for a snug match.
If there is any visible void about the inserted lock, seal it with an all-surface epoxy paste.
Checking Installed Mailbox Lock
Make certain that the pair of keys provided with the new mailbox lock perform appropriately. If not, take them to the retailer of the mailbox lock and request an immediate replacement.