Garbage Disposal Mount –
A garbage disposal flange is the portion of the unit that connects it to the underside of the sink drain. It screws onto the drain and then holds a mounting bracket for the garbage disposal. There are usually three screws that are utilised to hold the disposal to the flange.
When there is a problem with the garbage disposal chances are very good that you will need to have to get rid of it from the flange in order to operate on it or replace it. This is not a hard method, but there are some factors you want to bear in mind to make the job simpler.
1- Turn Water and Energy Off
Just before working on any element of the garbage disposal technique you must shut off the water. This will ensure that you do not get flooded out as you take away the disposal unit. Also, just before removing the flange from the drain pipe, run the faucet to let the water run out of the pipes. Be sure to turn off the electricity as nicely.
2- Do Not Force a Rusty Problem
If the garbage disposal flange has been installed for numerous years, you may find that there is going to be considerable rust. This rust will hold the flange in position which will make it really tough to take away. A lot of do-it-oneself-ers will attempt to force the flange totally free by using a huge plumber’s wrench. This is a mistake as it can twist the pipe, warp the flange, or even crack the underside of the sink.
When faced with the concern of a rusted disposal flange the greatest factor to do is to use some penetrating oil on it. Shake the can and then spray it on the flange. Let the oil sit on the flange for a few minutes. This will let the penetrating oil to perform on the rust to cost-free up the flange with no twisting or breaking pipes. Then use a pair of slip joint pliers to turn the flange.
3- Pry Flange with Flat Screwdriver
The flange is going to be seated in the bottom of the sink, or straight under the drain. In order to take away the best ring of the flange you will require to use a flat screwdriver to pry it up. Function around the flange in modest increments to make certain that you do not bend it. If the flange is bent then it will not be capable to be reused.
four- Eliminate Old Putty
One particular of the items that will stay when you remove the old disposal flange is the plumber’s putty. Make confident to take away it with a flat scraper ahead of you replace it. You will also want to remove the putty from the disposal flange if you are going to reuse it. If it is left on the surface it will interfere with the way it sits.
5- Do Not Let Disposal Weigh It Down
Just before you eliminate the disposal flange you need to initial release the weight of the garbage disposal from it. The three retaining screws are removed and the disposal unit lowered to the bottom of the cabinet prior to any work on the flange need to commence. This will lighten the load on the part as you work on it.