Things You Probably Didn’t Know About Skunk Repellent Lowes

Skunk Repellent Lowes –

Skunks usually breed in the spring, from February to May. A second mating may possibly occur later, if the skunk did not discover a mate or fails to impregnate. Young are generally born from Could-June, with the typical litter becoming five-eight babies. Young are weaned at 8 weeks and typically stay with the mother until they are 2-4 months old. Some juveniles will keep with their mothers or siblings till the following spring. Skunks are typically nocturnal, coming out well soon after dark.

Skunk Repellants

  • Cayenne pepper
  • Repel ® Granules – A industrial dog and cat repellant, available at most pet shops or garden centers. The active ingredient is nonyl methyl ketone. Some other brands are Boundary ® and Dog-Gone ®.
  • Hot Pepper Repellant Recipe
    You need:
    1. One particular chopped yellow onion
    2. One chopped Jalapeno pepper
    3. A single tablespoon of Cayenne Pepper
  • Boil ingredients for 20 minutes in two quarts of water. Then let it cool and strain the mixture by way of cheesecloth. You can apply this with a pesticide sprayer or a spray bottle. This will deter just about any animal from an area where it is applied. The only draw back is that it only lasts for three to 5 days.

Mechanical Repellants

Scarecrow ® by Contech is a motion-activated sprinkler. It works wonderful for maintaining most animals out of yards or large areas. For more information, check out Contech or contact at 1-800-767-8658.

Skunks on the Premises

  • Be sure to eliminate all meals sources such as pet foods, birdseed, etc. If your pets have to be fed outside, then eliminate all meals at night.
  • Use metal or heavy plastic trash containers. Maintain the lids securely fastened to prevent odors from escaping. If needed, safe lids with bungee cords, ropes, and so on. that have been soaked in Tabasco sauce ® or the commercial repellant, Ropel ®, accessible at garden, hardware, pet or feed stores. If they still get in, you can pour about one cup of ammonia in the trash can each week, following the trash has been picked up. Rubbermaid ® tends to make a trash can with a screw on the lid. You ought to constantly attempt to shop trash in a garage or a shed.
  • Preserve BBQ grills clean or stored in a safe place.
  • Light the area with flood lights or motion detector lights. Motion detector lights usually operate the ideal.

Skunks Under a Porch or Cement Slab

  • Use the Hot Pepper Recipe as the first technique of action.
  • Spray the repellant all around the den region. Also, spray about the entry and just a handful of inches into the hole. Don’t spray deep into the hole or the skunk may reciprocate.

Or attempt:

  • The next day, cover the entry. Wadded up newspaper stuffed into the entry hole performs excellent, or if there is dirt about the entry you can cover the entry location with loose dirt. Do not pack the dirt down as that may trap the skunk below the porch or cement slab.
  • Roll rags into a tight ball and tie with twine. These should be the size of a tennis ball or smaller. Soak these in ammonia until completely saturated.
  • Employing a piece of stiff wire, such as an opened clothes hanger, place the rag balls into the burrow as far as you can and cover the hole lightly with dirt or wadded newspaper.
  • Observe the hole for a handful of days. Re-cover the hole whenever you see it open. When the hole has not been uncovered for a couple of days, the skunk is out. If, after 4 days, the skunk has not moved, then on the fifth day, repeat the method from the starting, like new rags and ammonia. The skunk will usually move out on the first or the second evening.
  • After the skunk is gone, skunk-proof the region to stop reoccurrence. In places where there is too much open space for ammonia to be successful, like crawl spaces or under wood floorings, then construct a one particular-way door.

One-Way Door

  • Use only if ammonia rags don’t function. If the skunk is in a crawl space or below wood flooring there may be also considerably open air space for the ammonia rags to work.
  1. You can obtain a a single-way door, produced by Tomahawk Trap Co., available from ACES. Their telephone quantity is 1-800-338-ACES or visit Tomahawk Live Trap’s internet site at
  2. Or, construct your own one particular-way door, using the following directions:
  • Begin with a 10 in. x 8 in. piece of 1/2 in. plywood.
  • Measure in 2 in. from all 4 sides and draw a line.
  • With a jigsaw, reduce the middle out of the plywood. You now have a frame that is two in. wide on each side and a piece of plywood that measures eight in. x 6 in.
  • On the 8 in. x 6 in. piece, measure in 1 in. from all four sides and draw a line.
  • Making use of a jigsaw, reduce the middle out and discard the excess.
  • The eight in. x 6 in. piece should fit inside the ten in. x eight in. piece of plywood. This is the door and frame.
  • Mount the door, with hinges or wire, to the 10 in. side of the frame.
  • You may have to sand the door if it doesn’t match flush inside the frame.
  • Attach a piece of hardware cloth, no larger than 1 in. x two in., to the door with nails or staples.
  • Attach a small piece of wood across the bottom corners of the frame so that the door will only open one particular way.
  • Get a piece of hardware cloth or welded wire no larger than 1 in. x 2 in., that is 2 ft. to 3 ft. big. The size will vary depending on the size of the skunk entrance.
  • Reduce a hole in the middle of the wire or hardware cloth eight in. x six in. and attach it to the frame and door.
  • Attach the whole assembly to the skunk entrance, making use of nails or stakes.
  • You want the door to be at ground level and be sure that the door is opening to the outdoors, away from the skunk entrance.
  • Bend the hardware cloth or wire away from the entrance and bury it so that the skunk cannot dig below the door.
  • When the skunk is out you can block the entrance or skunk proof it.
  • How to tell if the skunk is out:
    • There should be some scraping or digging about the a single-way door. This indicates that the skunk is out and can’t get back in.
    • Put a layer of flour on the inside and outdoors of the door soon after the 1-way door has been installed for one to two nights. Any footprints in the flour should be outdoors the door with none inside. This means the skunk is out.
    • If you have any doubt, then smooth out the dirt on both sides of the door with your hand or a tool, reapply the flour and observe. When a couple of days have gone by with no footprints, the skunk is most likely gone.
    • An additional way to check is to open the door and shove a few pieces of wadded up newspaper into the skunk’s entrance. If the paper stays in place for two to 3 nights, then the skunk is gone.

    Note: You could want to proof the impacted area initial, so once the skunk is blocked out, it won’t be capable to dig a new entry.

    Skunks in Window Wells or Dumpsters

    • Offer a ramp made of a rough surface. You produced require to staple, nail or duct tape a heavy piece of cloth so that the animal can get a great grip.
    • Place the ramp at an angle, so that the animal can crawl out.


    1. Use a net with at least a five-ft. pole. Slowly, scoop out the skunk. Gently lay the net on the ground so that the skunk can crawl out.
    2. Tie a piece of rope to a bucket or pail, then location a small quantity of cheese, dried cat or dog meals in the bucket. Employing the rope, reduced the bucket into the window well and lay it on its side. When the skunk goes into the bucket, gradually stand the bucket up, lift it out, and place it on the ground. Quickly back up slowly until you are about ten-15 feet away. Then, use the rope to gently pull the bucket more than.

    Skunks Beneath Mobile Homes or Trailers

    • Remove 1 panel of skirting from every single corner this usually operates if the skunk is living above the ground or in articles stored beneath the trailer.
    • If this does not work, then the skunk has possibly burrowed underground and most most likely, under a concrete slab beneath the trailer. In this case, hold the corner skirts off and try the ammonia techniques outlined beneath, Skunks beneath a Porch or Cement Slab.

    Note: Be confident to skunk proof after they are gone.

    Skunks Coming Via Pet Doors

    • Mount floodlights or motion detector lights above the pet door.
    • Lock and secure the pet door at night.
    • Spot a piece of plywood or cardboard outdoors of the pet door sprinkle a liberal amount of Cayenne pepper or Repel ® granules. Be sure to lock the pet door that night and don’t forget to do so for numerous nights. For the duration of the day, you can remove the repellant so that your pets can use the door. Typically, after a couple of visits, the skunk will remain away from the pet door. The easiest strategy is to merely lock your pet door each and every night at sunset. Typically, soon after just a couple of nights, the skunks will cease coming to your pet door. When the skunk realizes that he can not access your pet door for food, he will not want to waste time or energy coming to your house.

    Note: If you reside in skunk habitat, a pet door for dogs or cats is not a good thought. If the skunks find out it, they will use it to come into your property in search of food. Not only will wildlife use them but also small humans can enter them and what they take will be more valuable than what the wildlife desires.

    Skunks Beneath Sheds or Barns

    • Use the Hot Pepper Recipe all about and beneath the edges of the shed.
    • Usually there is also considerably airspace under sheds or barns for ammonia alone to be effective.
    • Attempt the ammonia approach outlined under: Skunks beneath a Porch or Cement Slab.
    • Spot a radio tuned to a speak station in the shed or barn. If you know exactly where the skunk is located under the barn or shed, location the radio as close to it as attainable.
    • Any human activity in the barn or shed will also discourage the skunk from staying there simply because it will not feel secure.

    Remove Skunk Odor from Space or Clothing

    • Use Neutroleum Alpha, available from Vigon International – you may possibly make contact with them by way of their internet site at, or by calling them at 1-877-VIGON-39.
    • Spot Peppermint or Spearmint Oil on cotton balls or mix with water in a water bottle and use as a spray.

    Remove Skunk Odor from Human Skin or Pets

    • For pets that have been sprayed, bathe the animal in a mixture of one particular quart of three% hydrogen peroxide (from a drug store), 1/4 cup of baking soda (sodium bicarbonate) and a teaspoon of liquid detergent. After five minutes, rinse the animal with water. Repeat if needed. The mixture have to be utilised after mixing and will not function if it is stored for any length of time. Caution: This mixture may possibly bleach the pet’s hair.
    • Nature’s Miracle Skunk Odor Remover ®, offered from veterinarians or pet provide retailers.
    • Massengill ® douche, it really is the least expensive and the easiest to discover. (Stop Laughing!)
    • Vinegar and water will also function. Vinegar is an acid which breaks down the alkaloid skunk spray.

    Note: Keep away from eye speak to when using any of these methods.

    Skunk Proofing

    For use about concrete slabs, patios, steps or sun decks.

    1. Dig a trench about patio or deck 1′ wide x 1′ deep.
    2. For concrete slabs, acquire 1″x 2″ welded wire fencing (offered at hardware retailers) to go about the concrete slab. Try to get welded wire that is two feet wide. Bend the welded wire into an “L” shape and lay it in the trench so that the wire goes 1 foot down and 1 foot away from the patio. Then fill in the trench.
    3. For sun decks, buy 1″x 2″ welded wire fencing, get it in a three-foot or four-foot width, depending on how higher the deck is above the ground. Measure the distance from the bottom of the frame of the deck to the bottom of the trench that you have dug. Measure out that exact same distance on your welded wire and at that point, bend the welded wire at a right angle (“L” shaped). Be positive that the “L” shaped element is 1 foot wide and trim off the excess if it is wider. Spot the welded wire into the trench. Attach the wire to the bottom of the deck and fill the trench in. See the image beneath:

    Reprinted with permission by Urban Wildlife Rescue.

Read More:  Unbelievable Facts About Widening A Doorway

Skunks |