Replace Single Handle Shower Valve –
When a shower faucet begins to leak or drip even when shut off, it could be cracked or broken. It might be time to replace it. When getting for the shower faucet replacement, preserve in mind that you require the precise very same measurements in order for it to fit into the valve. Think about also the sort of shower faucet that you have at the moment installed. If it only has a single deal with and functions to dispense both cold and hot water depending on how far you turn it, then it is a single lever shower faucet.
There are several sorts of single lever faucets but regardless of their minor variances, they function the same way. Beneath are the common methods on how to replace this variety of shower faucet.
Step 1-Turn off the Water Source
Locate the water heater and tighten the valves to cut off the water going into the faucet. Also turn off the water at the water principal exactly where it enters the residence. Turn the shower faucet back on and drain the remaining water in the pipes by permitting all the water to flow out.
Step two-Prepare to Remove Shower Faucet
Lay out all the tools and components required for straightforward access. Cover the drain with an old towel to stop screws from slipping down into it and to safeguard the tub from falling tools.
Step three-Get rid of the Faucet Handle
Using a tiny flathead screwdriver, poke its tip into the side of the plastic cover situated at the top portion of the faucet deal with. Pop off that plastic cover and set aside. Inside the hole, find the screw and, with a Philips screwdriver, turn the screw to the left to loosen and take it out along with the manage. With a channel lock, grab onto the cover plate, if there is any, and pull it out. Line up the Faucet Manage parts for easier re-installation later.
Step 4-Get rid of the Old Shower Faucet
Find the metal retaining ring or retainer clip or nut, whichever applies, that holds the cartridge in place and, with an adjustable wrench, loosen it and take it out. With a pair of pliers, grasp on the tip of the old shower faucet, and pull it straight out from the valve.
Step five-Set up the New Shower Faucet
Place on the new shower faucet or cartridge into the open valve. Slip back in the retaining ring or retainer clip or nut, whichever applies, and tighten to secure employing an adjustable wrench.
Step 6-Replace the Faucet Handle
Insert back the cover plate, if any, the faucet manage, and the screw. Tighten the screw with the Philips screwdriver and push back the plastic cover over it.
Step 7-Turn on Water Supply
Open the water valves controlling the flow of water into the property and these on the water heater. Turn on the new water faucet to test its flow.
If you want to replace just the shower deal with, you can discard the old faucet handle and stick to Measures six and 7 employing the new shower deal with. Otherwise, just refer to the manufacturer’s guidelines that come with the product and set up accordingly.