Stained Glass Lamp Repair –
Rather than throw away or spend income on repairs for your broken or damaged stained glass lamp shades, you can follow the straightforward methods beneath to attempt to fix it.
Step 1 – Receiving Ready
Get rid of the stained glass lamp shade from the lamp base and situate it on a flat surface. Make a rubbing of the soldered seams surrounding the broken glass with paper and pencil or any other marking materials.
Step 2 – Breaking Up Glass
Use a glass cutter to score a cross-hatch pattern on the glass. Use pliers to break and get rid of shards. When undertaking this, pull out and away from the lamp so as not to spot additional strain on the surrounding pieces of glass, leaving the operating region clean. Obtain a cardboard box larger than the lamp shade and block it up with wadded newspaper. Rest the shade in this box, employing the newspaper to prop the lamp so that you can solder on your perform surface.
Step three – Soldering a Glass
Apply liquid or paste fluxes on the solder bead adjacent to the broken glass. Heat the solder with your soldering iron. At the identical time, use the tip of the iron to do away with excess solder from the seams on each sides of the broken pane. Be vigilant to run off the foil on the surrounding pieces of glass intact. At the exact same time, use needle-nose pliers to pull away smashed or broken foil.
Step 4 – Patterning the Glass
Incise out the rubbing of the broken or smashed glass section and mark out it onto new glass with permanent or steady marker. Incise out the glass and grind to fit the location. Verify to make confident it fits just before foiling. Bring into play copper foil to enfold the edges of the new piece of glass.
Step five – Applying the Glass on the Broken Component
Adjust the foil on the new piece of glass as effectively as the foil on the pieces of glass adjoining the missing piece. Tin the new piece of glass by soldering a thin coat of solder over the foil. Reapply flux to the solder on the new piece and spot it into the new spot. Use electrical tape on the inside of the lamp to hold the glass in place. Path solders the glass into place by soldering tiny amounts of solder at numerous spots where the new piece touches the surrounding pieces.
Utilizing your soldering iron, melt and apply solder to the front seams of the complete piece of new glass and the surrounding pieces. When the front is complete, get rid of the electrical tape and flux and solder the inside.
Step 6 – Finishing Touches
When the soldering is full, use dish soap or soap created for removing flux to clean the lamp shade. If a patina was used on the rest of the stained glass lamp shade, use the very same type on the new section so that it will match. Adhere to up with an application of glass wax to the complete piece.