How To Replace Kitchen Sink Drain – A sink strainer basket is the unit that connects the sink to the plumbing and prevents big debris from clogging the plumbing system. Although a properly installed sink strainer normally will not have to be replaced for a long while, it is fast and easy to set up. When the time comes to replace your sinker strainer, you will only want about 1 hour and a handful of things from your neighborhood home improvement shop.
Remove Old Strainer
Ahead of you can set up the new strainer, you have to remove the old strainer from the sink. To do this, go underneath the sink and disconnect the drain pipe from the bottom of the strainer. Use your channel locks or pipe wrench to take away the huge locknut that is securing the strainer in spot. This can get a bit tricky. As an alternative of separating, sometimes the strainer will turn with the locknut as your attempt to take away it. If this happens, you will require to wedge a pair of needle nose pliers into the bottom of the strainer and safe it while you are removing the locknut. This is achievable to do by yourself, but it is considerably less difficult with a helper.
With that removed, you can slip off the rubber gasket and eliminate the strainer.
Clean Up Sink Opening
The sink opening will be covered in old, difficult plumber’s putty. You will require to get rid of the putty and make confident that the opening in the sink is clean and dry. The ideal way to eliminate the putty is with a plastic putty knife. Plastic is the best selection here simply because you do not want to harm the surface of the sink.
If you uncover that the putty is rather stubborn you can use steel wool or even a bit of paint thinner to help in the removal. Make certain you wipe the opening cost-free of debris and residue.
Add Plumber’s Putty
After the sink opening is clean, you can add the plumber’s putty. You want to use a golf ball size quantity of putty and form it into a extended snake-like shape. You will wrap the length of the putty around the opening of the sink.
Set New Sink Strainer
Now that the plumber’s putty is in location, you will sit the sink strainer down into the opening and apply even stress to the flange. This will push the flange down into the putty and form a seal. Putty will squeeze out from around the flange. You will need to have to wipe this off. Putty will also squeeze from around the strainer beneath the sink. This also wants to be removed.
You will then add the rubber gasket and metal locknut and tighten it with your channel locks. If your strainer is imprinted with a logo, you will want to line it up at the center point for a expert finish. The final step is to reattach the drain pipe to the bottom of the strainer.
That is it. You have replaced your sink strainer basket following these swift and effortless guidelines.