Learn All About Replace Washing Machine Valve

Replace Washing Machine Valve –

If you notice the washing machine filling up with water or if it does not dry the garments properly, it is an indication that you need to have to replace the water inlet valve. With the appropriate tools and this guide you will be able to replace the inlet valve oneself. Here’s how you do it.

Step 1 – Buying the Water Inlet Valve

Go by way of the owner’s manual and discover out the specification of the water inlet valve. Make a note of the serial quantity of the water inlet valve and head to the hardware store to get a replacement.

Step two – Water Provide

Ahead of you start off with replacing the water inlet valve, reduce the water provide to the washing machine. There typically is a water provide knob at the washer or quit the water supply to the whole home.

Step three – Provide Pipes

Find the tubes or pipes that connect to the washing machine. Use pliers to disconnect the hot and the cold provide hoses.

Step four – Bucket

After the supply tubes are disconnected, the accumulated water will flow out. It would be best to place a bucket to make certain the water doesn’t spill and spread on the floor.

Step five – Drain Hose

Removing the drain hose will provide you with better accessibility. The tube is held in place by a clamp like technique. Pull the tube out of the machine.

Step 6 – Access Panel

The subsequent step is to take the access panel off. Only then will you be in a position to attain the water inlet valve. The access panel is held collectively by screws. Use a screwdriver to cost-free the panel.

Read More:  Ten Quick Tips For Eco Friendly Living Room Furniture

Step 7 – Take the Access Panel Off

Right after taking the screws off, the panel will loosen up. All you have to do is slide it and lift it. This will take the access panel out of the washing machine.

Step 8 – Disconnecting the Wires

There will be wires that connect to the water inlet valve. These wires facilitate in the activation of the water inlet valve. There will be two connectors each and every on the hot as effectively as the cold valve. Take a note of the placement prior to you disconnect the wires.

Step 9 – Eliminate the Water Inlet Valve

With the help of a screwdriver loosen the hold of the screw on the left hand side of the water inlet valve. As soon as the screw is removed, the water inlet valve slides out of its hold.

Step 10 – Disconnecting the Water Line

Find the water line, which appears like a hose, from the water inlet valve. Appear for the clamp on the valve. The water line sits close to it.

Step 11 – Installation

Now take the new water inlet valve and connect the water line that you removed in Step ten to the new valve. Slide the clamp back into position. You may well need to have to use pliers.

Step 12 – Lastly

Location the water inlet valve into its slot and screw it on. Reconnect all the wires and location the access panel back in position. Reconnect the provide and drain tubes.

How to Replace a Washing Machine Water Inlet Valve