Particle Board Flooring – Particle board may be 1 of the most understated supplies out there. Not only is it an affordable constructing material, it really is versatile. It really is not generally utilised for a finished exterior with no a laminate covering, but it is sufficient as a subfloor, under siding, or as a frame for cabinets as is. This is simply because it is created from scrap supplies ground down and mixed with an epoxy and then formed into a board. Raw particle board can be improved by staining, just like all other types of wood, and this post will show you how.
Prepare the Particle Board
Particle board is really porous and, as such, it should be sealed prior to staining. Sealing the wood will limit attainable uneven coloring or darkening of the wood, and the material will also last a lot longer. Even so, ahead of you can apply sealer, you are going to need to make sure the board is clean. Mix some detergent with warm water in a bucket, and then soak a rag in it to clean the surface. Scrub it nicely, as you require to make sure the surface is free of each dirt and oil. This is done so the sealer and the stain can be properly absorbed. Permit the particle board to dry for two days so all the moisture is totally gone.
If you are organizing to use particle board outside, make certain you acquire exterior range so it can stand up to altering climate conditions.
Pour some of the sealer into a paint tray, and roll on two to three layers. You may also use a rag instead of a roller. As previously mentioned, this will aid preserve the stain from getting uneven, but it will also assist the material final longer. Seek advice from the label on the sealer and let the particle board to dry for the recommended quantity of time. Then, as soon as it’s dry, you can apply the stain.
Stain the Particle Board
Clean or get a new paint tray and pour some stain inside. Roll this onto the particle board in three-foot squares this prevents the stain from drying prior to it can be wiped down. If there is excess, you can wipe it off with a clean rag within five minutes of application, but when the rag is entirely saturated, throw it into a bucket of water, as stain can be flammable. Let your application dry for at least eight to 10 hours. Apply a second coat afterward If you want a darker shade.
Seal Once again
If you want the particle board to be washable and durable, then apply two layers of sealer over the stain. Polyurethane or acrylic varnish will be suitable for indoor use, but if your board is going be outdoors, you will want to use acrylic or an oil-primarily based varnish. However, please keep in mind that oil-based varnish will yellow over time so use with caution and be ready to reapply it as required.