Pool Timer Not Working – When your pool timer stops functioning, it does not necessarily imply that you will have to rush out and buy a new one. There are several motives why your pool timer may possibly be malfunctioning. Timer pins can be missing or the timer could be defective. Your timer could be set incorrectly or the timer may possibly not be obtaining energy. In order to locate the problem of your pool timer, troubleshooting have to be carried out to figure out the problem. With the suitable troubleshooting understanding and instruction, your pool timer can be functioning normally once again ought to your issue be a non-working motor.
Verify that Timer Is Functional
Locate the two timer pins on your timer. Take a very good look at the position of the pins and create down the locations. Leave the paper inside your timer box so that you do not mistakenly misplace it. Your timer is on a 24-hour cycle. Because of this, you will want to return to the timer in 24 hours to see if the location of the pins are various. If the pins are in a diverse location, power is being supplied to your timer and it is functional.
If the pins have not moved, you are not getting power to the timer. Verify the manual override switch beneath the timer dial and make certain that it is on. If it is on, verify the circuit breaker to make sure that it is in the “On” position. If it is on, your timer will want to be replaced.
If the instructions in Step 1 don’t yield good results, it is essential to replace your timer. It is suggested that you consult a specialist electrician to set up the timer. This ensures that the measures to installing the timer are done professionally and will not compromise your security. If Step 1 does yield optimistic final results, move on to Step 3.
Adjust Timer Wheel
At times the lead to of a malfunctioning pool timer is the adjustment of the timer wheel. The time bar is situated in the center of the timer wheel. If you want to set the time, you should take two fingers and pull the wheel gently toward you away the timer box. You will be capable to rotate the wheel when it is about 1/8 inch out. You want to turn the wheel till the timer reflects the right time with the timer marker at the front of the wheel.
Adjust Timer On and Off Pins
If every little thing else is in order with your timer to this point, you will want to adjust the timer “On” and “Off” pins to set the time to turn your filtering system on and off. Use your screwdriver to loosen the screw that holds the pin in place. Adjust only one particular pin at a time. Be sure not to loosen the screw too a lot so as not to lead to the screw to fall from the wheel and turn into lost.