Toe Kick Heater –
Toe Kick heaters are compact, easy machines which makes troubleshooting your Toe Kick heater a rewarding and cost powerful method. Numerous frequent problems have basic solutions, but as usually, proceed cautiously with any electronic device.
My heater won’t turn on.
1st, check the fuse or energy box to make certain it is receiving energy. Verify your owners manual to see if your heater is equipped with a manual reset switch which can call for resetting. If the unit is receiving power, turn up the thermostat to a greater setting. Take away all obstructions which could be limiting airflow such as furnishings, plants, curtains, and towel racks. Make confident the heater has been appropriately cleaned and is not clogged with dust or debris. Check the owners manual to see if the model of your heater is authorized for the region it is installed. Some heaters have limitations such as water (close to a dishwasher or also close to a sink) or too close to carpeting, which can result in damage to the method.
My heater will not stop operating.
The temperature around the heater may well be different than the temperature inside the room causing the thermostat to stay on. If the problem persists even when the thermostat is turned down, the thermostat may possibly need to be replaced or the heater is experiencing low wattage.
My heater appears also noisy.
If your heater is not securely mounted it will make far more noise. Make positive the screws on the leading, bottom, and grill are securely fastened. The bottom of the heater can also be supported using adhesive foam in order to lessen rattling. One more choice is to check that the voltage the heater is receiving is the right voltage for the heating unit.
Heater turns on, then it stops.
The heater will turn off if the area has reached the set point on the thermostat. Turn up the set point on the thermostat to see if the heater will continue. The internal workings of the heater may well also be reaching intense temperatures causing it to quit. Verify to make positive there are no obstructions and clean of dust. The voltage might be wired incorrectly or the provide wires might not be sufficient.
Must the Heater glow?
No. The airflow may well be blocked so make certain the heater is clean and there are no obstruction within the grill. The heater could be wired to the incorrect voltage or the element may want to be replaced.
My heater is so hot it trips the limit switch.
Make certain the airflow of your heater is not blocked. Clean the heater and grill of all dust and debris which may possibly also be causing overheating. If the problem persists the heater may be wired to the incorrect voltage causing it to attain really high temperatures. Verify the voltage and supply wires to assure the right voltage is being reached.
The fan motor is running too gradually.
If the voltage does not match the heater provide rating the fan will run irregularly. Make sure the voltage each inside the supply wires and that of the heater are correct.